Split, Swap, Combine Elements

Use the Edit: Split tool to split quad elements and edges, combine tria elements, and swap element edges. Second order 2D elements are also supported.

1. From the Discrete ribbon, click the Edit > Split tool.

   
   
   Figure 1.

   Elements are colored according to how well they adhere to the pre-set quality requirements defined in the criteria file.
2. Optional: On the guide bar, click to to define the options used to edit elements.
3. Select an element issue type from the guide bar.

   Quality

   Checks for quality as defined in quality criteria.

   Intersections

   Checks for intersecting elements.

   Face angles

   Checks for folded or sharp angle elements.

4. Optional: Find all elements at or below a certain quality level.
   1. Click Find on the guide bar.
   2. Increase or decrease the number of layers around patches of failed elements by clicking or on the guide bar.
   3. Review the next or previous patch of failed elements by clicking or on the guide bar.
5. Select a split method from the guide bar drop-down menu.

   Option	Description
   Split	Split an element or element edge by left-clicking. Swap an element edge by holding Ctrl while left-clicking on an element or edge. Additional clicks will cycle through the possible edge positions. Combine two tria elements by holding Shift while left-clicking on their shared edge.
   Graphical Lines	Draw continuous single or multiple graphical split lines. Click Split. Figure 2.
   Element Selection	Select elements to split. Click Split. Figure 3. Note: When you split elements at fillets or curved faces, the middle nodes are projected back to parent edges/surfaces by default upon splitting. Figure 4.
   Solid	Select the elements to split. Select a method for splitting solid elements Hexas: split into hexas. Tetras: split into a minimal number of tetras. Symmetric: split into symmetric sets of tetras suitable for CFD. Click Split. When you split elements whose nodes are associated to a surface, the new nodes created are also on the surface. All split operators work on both first and second order elements.
   Layer	Select nodes to define the direction of split/combine/delete. Two subsequent node selections define a direction. You can select multiple node pairs simultaneously, but they should be neighboring nodes. You can use By Path in Advanced Selection to define multiple splits and works for split only. Select a layer method. Split: split hex elements along edges. You can select options for biasing while splitting layers. Combine: combine neighboring elements. Delete: delete layers of elements. Diagonal: split a single element along the diagonal. Optionally, select the Elements check box and select elements to split. Click .
   Combine	Select the elements to split. Click Combine.

   Tip: You can toggle graphical previews from the options menu.