HMIN_start_trim_line()
Signals the start of a trimming line.
Syntax
void HMIN_start_trim_line (int outer, int preference);
Type
HyperMesh hminlib Function
Description
Signals the start of a trimming line.
Inputs
- outer
- 1, if this is the outer trimming loop of the current surface; otherwise, 0.
- preference
- Determines the type of trimming. Use:
- 0 - No preference.
- 1 - Object space trimming preferred.
- 2 - Parameter space trimming preferred.
Example
A trimming line consists of the start signal (this command), followed by a parameter space line, an object space line (or both), and then the end signal.
It is presumed that the parameter space line represents the object space line in the parameter space of the surface.
This command is only valid after a call to HMIN_startsurf() and before the corresponding call to HMIN_endsurf().
Errors
None.