Create, Edit, and Display Tensor Plots

Use the Tensor tool to show stress and strain directions and magnitudes for various solvers from elemental values.

Restriction: Only component display mode is currently supported.
  1. From the Post ribbon, click the Tensor tool.


    Figure 1.
  2. Select a tensor plot using the drop-down menu on the guide bar.
  3. Optional: Click the Create Tensor satellite icon to define a new tensor plot.


    Figure 2.
  4. Optional: To review and edit the current plot definition, click on the guide bar.
  5. Optional: Select a subset of components or elements on which to apply the plot.
    By default, the plot is applied to the entire model.
  6. Click Plot to display the plot.
  7. Click one of the following:
    • - Save changes and exit the tool
    • - Clear the plot
    • - Exit the tool without saving changes
Tip:
  • Plots are based on the current load case and step, which can be reviewed and updated from the status bar or the browser.
  • Existing plots can also be displayed or cleared using the plot icons in the Results Browser.
  • Editing the definition for a displayed plot will automatically update the graphics. For large models, editing the plot definition may be faster if the plot is not displayed.